常見例句Changshu power plant STW 300MW generator rotor shaft repairing welding. 6. 5，已完成常熟電廠300MW發電機轉子大軸補焊。I also like to clean the main rotor and tail rotor shaft and lightly lubricate them with lube oil soaked tissue paper. 我還建議在擦凈主軸和尾軸后用沾了潤滑油的紙巾擦上一些潤滑油。Insure Rotor shafts are free from scratches, dings, and have chamfered edges to facilitate sleeve and bearing installation. Lubricate shafts with light oil. 確保轉子軸不受任何擦痕碰撞和有倒角邊;以方便襯套和軸承的安裝.;并用輕度油潤滑軸You can adjust turns tension by tightening the inside stop nut on the rotor shaft against the backplate to provide a more pleasing tension. 我用硬質合金尖劃針作標記, 當然任何尖的物體均可利用。必要時，你也可以使用鉛筆圓規的針尖作標記。分開你剛才標定的動片和定片。將所有的定片疊在一起。Features: use pneumatic landscape orientation pressurization, press commutator into rotor shaft, can exactly aim at rotor slot and commutator, tooling changing conveniently. 特點：采用氣動橫向加壓，將換向器壓放轉子軸內，能準確地對準轉子槽與換向器相對位置更換工裝方便。Some of the positions of rotor shaft minimize the inter-lobe clearance along the contact line which is in the hermetic segment, therefore they cause rotor interference possibly which lead to rotor abrasion or rotor seizing-up. 其中部分位置關系使接觸線上密封段的齒間間隙顯著減小,從而增加了該種位置關系下轉子擦傷、咬死的可能性。 返回 rotor shafts